Pfisterer CONNEX - 6. Assembly Accessories; 6.1 Required Tools

14 Assembly accessories PFISTERER CONNEX cable connector Size 3 and 3/S
6. Assembly accessories
Special tools are required for assembly or disassembly.
6.1 Required tools
6.2 Recommended tools and accessories
Name Article No. Description
Hydraulic manual 827 017 002 For the axial pressing
compression tool on or pulling off
of the contact ring.
Compression 305 675 003
head size 3
Impact head 559 214 003 For the preassembly of the
size 3 contact ring.
Torx screwdriver 546 004 009 To tighten or loosen the
SW 6 screws of the CONNEX
cable connector.
Name Article No. Description
Measuring 559 223 001 For the efficient jacket removal.
template size 3
Stripping pliers 305 051 051 For axial and radial cutting of
the insulation to expose the
conductor.
Replacement blade 305 063 063
for stripping pliers
Peeling tool and 827 951 001 To remove the outer
outer jacket cutter jacket.
set
To peel off the easy strip semi-
conducting layer.
To bevel the conductor
insulation.
Chain 827 165 001 To hook assembly lever into
punched strip. Requirement:
M12 thread connection on
system.