16 Assembly / Installation PFISTERER CONNEX cable connector Size 3 and 3/S
7. Assembly / Installation
WARNING! Danger of injury!
Installation and assembly work may only be carried out by trained technical staff
while observing the safety instructions.
Inspect parts for completeness and flawless condition before beginning with the
assembly.
ATTENTION!
Damaged components may not be assembled!
Use only perfect parts!
1. Mark where the jacket will be cut (1)
on the cable approx. 30 mm below the
outer flange of the device connector.
For cables with wire ground screen:
L = depending on distance to ground
connection.
☞
NOTE!
See following page for cables with outside
diameter > 60 mm.
To Next Page
Loading...