Mixing pump RITMO L / RITMO M Overview - Operation
Material
26
2016-02-17
19 Material
19.1 Flowability / Flow characteristics RITMO L
NOTE!
The pump B4-2 L can be used up to 20 bar operating pressure.
The possible conveying distance depends mainly on the flowability of the material.
Runny materials, spattling compound, colours, etc. have good flow characteristics.
If 20 bar operating pressure are exceeded the mortar hose length has to be reduced.
In order to avoid machine faults and increased wear of the pump motor, pump shaft and the
pump itself, only original PFT spare parts such as
PFT rotors
PFT stators
PFT pump shafts
PFT - To use material hoses.
These are compatible with each other and form a constructive unit with the machine.
Non-compliance does not only cause loss of guarantee, but also bad mortar quality is to be
expected.
19.2 Flowability / Flow characteristics RITMO M
NOTE!
The pump B4-1.5 can be used up to 15 bar operating pressure.
The possible conveying distance depends mainly on the flowability of the material.
Runny materials, spattling compound, colours, etc. have good flow characteristics.
If 15 bar operating pressure are exceeded the mortar hose length has to be reduced.
In order to avoid machine faults and increased wear of the pump motor, pump shaft and the
pump itself, only original PFT spare parts such as
PFT rotors
PFT stators
PFT pump shafts
PFT - To use material hoses.
These are compatible with each other and form a constructive unit with the machine.
Non-compliance does not only cause loss of guarantee, but also bad mortar quality is to
be expected.
To Next Page
Loading...
