PG DRIVES TECHNOLOGY I-DRIVE TECHNICAL MANUAL – WARNING SUMMARY
2.8 Charger Interlock
The machine manufacturer is responsible for providing a means of preventing the use of the
machine while the batteries are being charged. PGDT accepts no liability for losses of any kind
arising from failure to comply with this condition.
2.9 General
The machine manufacturer is responsible for establishing the suitability of the particular wiring
arrangements used on the machine, for both normal use and stalled conditions. PGDT can make
general recommendations for wiring the i-Drive controller, but PGDT accepts no responsibility for,
and accepts no liability for losses of any kind arising from, the actual wiring arrangement used.
The machine manufacturer is responsible for ensuring that only the mating connectors specified
by PGDT on the controller’s specific data sheet or in this manual are used to connect to the
controller. PGDT accepts no liability for losses of any kind arising from failure to comply with
this condition.
The machine manufacturer is responsible for ensuring that suitable connectors are used and
securely mated throughout the machine wiring system and that the workmanship associated with
the wiring system is of a good enough quality. Failure to meet this condition could result in
intermittent operation, sudden stopping or veering, or even create a burn or fire hazard. PGDT
accepts no liability for losses of any kind arising from failure to comply with this condition.
2.10 Motor And Battery
It is the responsibility of the machine manufacturer to ensure that the mating female Fastons are
suitable for use on the intended application. PGDT accepts no liability for losses of any kind
arising from failure to comply with this condition.
2.11 i140 & i180
It is the responsibility of the machine manufacturer to ensure that the high current crimp
connections are suitable for use on the intended application. PGDT accepts no liability for losses
of any kind arising from failure to comply with this condition.
2.12 Programming Connector
This connector should only be mated with a dedicated PGDT programming tool, i.e. an SP1, DTT or
Industrial PC programmer. PGDT accepts no liability for losses of any kind arising from failure to
comply with this condition.
2.13 Crimping
Defective or poor quality crimps may affect the warranty of the controller. PGDT accepts no
liability for losses of any kind arising from failure to comply with this condition.
SK76977-07 107
To Next Page
Loading...
