iv | Page
V4.1
SAFETY MESSAGES AND WARNINGS
To ensure safe and reliable operation of the Phase Perfect
®
, it is important to carefully
read this manual and to observe all warning labels attached to the unit before installing.
Please follow all instructions exactly and keep this manual with the unit for quick and
easy reference.
Definitions of Warning Signs and Symbols
CAUTION: Indicates a potentially hazardous situation that could result in injury or
damage to the product.
WARNING: Indicates a potentially hazardous situation that could result in serious
injury or death.
HIGH VOLTAGE: The voltage associated with the procedures referenced could
result in serious injury or death. Use caution and follow instructions carefully.
READ THESE WARNINGS BEFORE INSTALLING
OR OPERATING EQUIPMENT!
WARNING: Risk of electric shock. More than one disconnect switch may be
required to de-energize the equipment before servicing.
WARNING: Risk of electric shock. De-energize the unit by disconnecting all
incoming sources of power, then wait 30 minutes for internal charges to dissipate
before servicing the equipment.
HIGH VOLTAGE: This equipment is connected to line voltages that can create a
potentially hazardous situation. Electric shock could result in serious injury or death.
This device should be installed and serviced only by trained, licensed, and qualified
personnel. Follow instructions carefully and observe all warnings.
WARNING: Installation of this equipment must comply with the National Electrical
Code (NEC) and all applicable local codes. Failure to observe and comply with these
codes could result in risk of electric shock, fire, or damage to the equipment.
WARNING: Grounding electrodes must be installed such that earth resistance is
25 Ohms or less, as specified by the NEC section 250-56. If surge protection is
installed, earth resistance must be 3 Ohms or less for full effect. Failure to meet these
requirements could result in serious injury or death and will void the manufacturer’s
warranty.
CAUTION: Circuit breakers, fuses, proper ground circuits, and other safety
equipment and their proper installation are not provided by Phase Technologies, LLC,
and are the responsibility of the end user.
To Next Page
