To Next Page
A
ashley13Aug 9, 2025
Why does the buzzer sound continuously on my Phcbi MIR-554-PA Laboratory Equipment?
- MMichelle ColeAug 9, 2025
If the buzzer of your Phcbi Laboratory Equipment sounds continuously, it could be due to several reasons. First, check if the set temperature is lower than the lower limit temperature; in this case, the lower limit temperature should be set at least 5°C below the set temperature, and adjust it after the chamber reaches the set operating temperature. Alternatively, the set temperature might be higher than the upper limit temperature; ensure the upper limit is at least 5°C above the set temperature, adjusting after the chamber stabilizes. Finally, remove any excessive heat sources from inside the chamber.
General
