System Monitor PSM 2
REV 1A – Software V3 Page 12
In this Submenu, the following settings are possible:
Load configuration from SD card
A previously saved configuration can be loaded from the SD-Card
Save configuration to SD card
The actual configuration is stored on the SD-Card
PowerPlex-Node (only for ETA PowerPlex)
If the PSM2 is used to send E-T-A PowerPlex switching commands, the address of the
E-T-A PowerPlex on which the notification information is available must be registered
here.
PSM-Node (only for ETA PowerPlex)
If the PSM2 is used to send E-T-A PowerPlex switching commands, the node address
under which the PSM2 sends his switching commands must be registered here.
Number of Pages
The number indicates how many consumer pages each with 6 buttons are displayed in
the PSM2. The maximum number of pages is limited to 4, which results in 24 switch
functions.
Start page
Indicates which consumer page is shown first.
Button X
For each button (screen-button) it’s possible to choose a symbol and the displayed
text. Also the command which relay on which relay module shall be triggered (relay
module number and relay 1-4) will be chosen in this submenu. An ETA PowerPlex
module can also be chosen from this submenu.
The number of the individual buttons are allocated as follows:
1 2 3 7 8 9 13 14 15 19 20 21
4 5 6 10 11 12 16 17 18 22 23 24
To Next Page
Loading...