System Monitor PSM 2
REV 1A – Software V3 Page 5
4.2 Installation and connection of the PSM2
Install the PSM2 in a dry and
visible place, so that it can be
read off at any time. The
necessary installation cut out is
88 x 88mm (3.5” x 3.5”), the
necessary minimum depth is
40mm (1.6”).
4.3 System arrangement PBUS
All PBUS components are connected via a PBUS network cable. The components can
be in any order or sequence.
Ensure that the terminators are installed at each end of the network. Without these
terminator resistors the PBUS will not function.
To Next Page
Loading...