DDC Instructions (Continued)
28
107T6 CRT
Go to cover page
Step 6: Save DDC data
Sometimes, you may need to save DDC data as a text file for using
in other IC chip. To save DDC data, follow the steps below:
1. Click (Save) icon (or click "file"-> "save as") from the tool bar
And give a file name as shown in Fig. 25.
The file type is EDID46 file (*.ddc) which can be open in WordPad.
By using WordPad, the texts of DDC data & table (128 bytes, hex
code) can be modified. If DDC TEXTS & HEX Table are completely
correct, it can be saved as .ddc flie to re-load it into DDC IC for DDC
Data application.
2. Click .Save
Step 7: Exit DDC program
Pull down the File menu and select Exit as shown in Fig. 26.
3. Click (Write EDID) icon from the tool bar to write DDC data.
Bring up " ready" a progressing bar on the left, then bring up the
Window as shown in Fig.24, click the " enter" button to finish Writing
4. Confirm Serial Number in User Mode
1) Press the button to turn off the monitor. Press the button
again to turn on the monitor.
2) Press the button to bring up the OSD main menu.
3) Press the button to select Extra Controls, press the button to
confirm your selection.
4) Confirm the Serial Number ''TY 000812'' is updated as shown in
Fig. 25.
Fig. 26
2. Access Factory Mode
2). [Push " " & " " buttons at the same time and hold it
]+[Presspower" "buttonuntillcomesout"Windowsscreen"]
=>thenreleaseallbutton,thenpress ,waituntiltheOSDmenu
with
Characters V32 107T6 V0.24 20040303 (below OSD menu) come on
the Screen of the monitor (see Fig. 23).
1). Turn off monitor.
Fig.24
MODEL SELECT
V32 107T6 V0.24 20040303
MODEL SELECT
V32 107T6 V0.24 20040303
Factory
Mode-------------
Indicator
Fig. 23
ENTER
000812
Fig. 25
107T6-DDC
107T6-DDC
107T6
To Next Page
Loading...
