35
Warning Message Table
Warning message table
Item Attention Signals Display Time Condition Attention off
1 CANNOT DISPLAY
THIS VIDEO MODE,
CHANGE COMPUTER
DISPLAY
INPUTTO 1024X768
@ 60HZ
30 mins This warning appears when theinput signal from your
computer is notinastandardvideo mode orisout of the
monitor’sscanning range.After 30 mins, monitor enters
sleeping mode.
No
2 NO VIDEO INPUT 30 mins This message appears when there is no signal inputbut with
cable while AC or DC while power on.After 30 mins, monitor
enters sleeping mode.
Yes
Show floating
menu
ATTENTION
SIGNAL OFF
3 CHECK CABLE
CONNECTION
30 mins This message appears when a signal cable is disconnected
while monitorisworking.After 30 mins, monitor enters
sleeping mode.
Yes
Show floating
menu
ATTENTION
SIGNAL OFF
4 ENTERING SLEEP
MODE
3 secs This message appears when monitorisaboutto enter power
saving mode.
No
5 WAITING FOR
AUTOMATIC
ADJUSTMENT
till auto
adjustment
finished
This message is displayedwhen theauto adjustment button
is pressed. It disappears when automatic adjustments are
completed.
No
6 USE 1024 X 768 FOR
BEST RESULT
Ontop of OSD
main menu
The message will show up at thetop of the OSD main menu
in redcolor when theinputresolutionisnotthe 1024x768.
Yes
7 OSD MAIN
CONTROLS LOCKED
3 secs /or Till
OSD MAIN
CONTROLS
UNLOCKED
appear
This message will appear 3 secondsto indicate the OSD
MAIN CONTROLS status when to lock or un-lock it by
pressing MENU(OK) button formore than 10 seconds while
there is video input from PC. This function provides the
alternativethat user can lock all the OSD main controlin
case user don’t want the FOS performance setting to be
changed, forinstance,during commercial exhibition.
No function when
push10secs (If
OSD lock then
attention off, not
any message and
only attention on)
8 OSD MAIN
CONTROLS
UNLOCKED
3 secs This message will appear 3 secondsto indicate the OSD
MAIN CONTROLS status when toun-lock it bypressing
MENU(OK) button formore than 10 seconds while there is
video input from PC.
No function when
push10secs
9 ATTENTION SIGNAL
ON
ATTENTION SIGNAL
OFF
3 secs
3 secs
This message will appear 3 secondsto indicate the attention
signals in ON or OFF status when to switch this function on
or off bypressing the AUTO button formore than 10 seconds
while at novideo input from PC.
Yes
10 THISIS85HZ
OVERSCAN, CHANGE
COMPUTER DISPLAY
INPUTTO
1024X768@60HZ
10 mins This message will appear 5 secondsinevery60seconds for
10 minutes when theinput of PC video timing is at 85Hz
mode.
Remark: AUTO is still functional in this mode
No
11 the window of OSD
MAIN CONTROLS
60 secs This message will appear when the OK buttonispressed. Yes
To Next Page
Loading...
