Travel lock
You can lock your Philips Shaver when you are traveling to ensure it does not switch on by accident.
To activate the travel lock press the on/off button on your shaver for three seconds. When the travel
lock is activated, a lock symbol flashes on your shaver.
To deactivate the travel lock press the on/off button on your shaver for three seconds. The lock
symbol will first flash and then light up continuously to indicate that the shaver is ready for use again.
Replacing shaving heads
To maintain your Philips Shaver it is important to regularly replace its shaving heads. Depending on
your shaver model, you may see a shaving head symbol flashing on your shaver or hear a beep as a
reminder to replace the shaving heads.
For most shaver models, the shaving heads should be replaced every two years. For instructions on
how to replace the shaving heads of your shaver refer to your user manual.
Note: After replacing the shaving heads, you need to reset the shaver by pressing the on/off button
for a few seconds.
Bath and tap symbol
If you see a shower or bath symbol printed on the back of your Philips Shaver, it means that your
shaver is waterproof and can be safely used with water while taking a shower or a bath.
A tap symbol printed on the back of your Philips Shaver indicates that your shaver is washable, and
can be cleaned with water. However, this does not mean that you can use it in the shower or bath.
A crossed out tap symbol means that your shaver is not washable and should be cleaned without
water.
To Next Page
Loading...
Need help?
General
