220B2 22” Wide 16:10 LCD Monitor
2010/02/10 PHILIPS 21 of 29
74 220BL2 LCD
General Product Specification
5.9 If paint is used
x RoHS required
x WEEE require
x If new painting type need to implement, refer to UN-D 1235.
5.10 Plastic mold tooling
x Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush,
weld lines, gate marks, ejector marks, etc.). Refer to “TYV61-90007”.
x Painting to cover up cosmetic defects due to molding is strongly discouraged.
x China RoHS mark requested.
5.11 Plastics flammability
x All Plastics to be Flame Retardant UL 94-HB or Better.
x Base / Pedestal to be Flame Retardant UL 94-HB.
x All major plastic parts (bezel, back cover) need to be molded from same resin.
x Plastic resin type selection should be referred to “plastic-Philips Pool monitor”.
5.12 Texture/Glossing of housing
x The texture area and texture no should follow Philips make-up sheet.
x The exterior surfaces shall have a uniform texture.
x Philips must approve the mold texturing.
x Detail document for texture refer to “UN-D249”, “UN-D 600”.
x < = 20 gloss units
5.13 Tilt and swivel base
x Tilt angle : -5 q +2/- 0 q (forward)
+20 q+ 0/- 3 q (backward)
x Swivel angle : -45~ +45 (220B2/220BL2/225B2/225BL2)
-65~ +65(220P2/225PL2)
x High Adjustment : 70mm ( 220B2/220BL2/225B2/225BL2)
130mm (220P2/225PL2)
x Portrait Display : 0~9˃ (220P2/225PL2)
To Next Page
Loading...
