HUDSON 9
82
5.6 Color for resin/paint - Per Philips make-up sheet
5.7 Resins
z RoHS required
z WEEE required.
z Resin type/selection refer to Project Book Section 7.2 Plastic material.
5.8 If paint is used
z RoHS required
z WEEE require
z If new painting type need to implement, refer to UN-D 1235.
5.9 Plastic mold tooling
z Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines,
gate marks, ejector marks, etc.). Refer to “TYV61-90007”.
z Painting to cover up cosmetic defects due to molding is strongly discouraged.
z China RoHS mark requested
5.10 Plastics flammability
z Bezel/Rear cover to be Flame Retardant UL 94-HB.
z Base / Pedestal to be Flame Retardant UL 94-HB.
z All major plastic parts (bezel, back cover) need to be molded from same resin.
z Plastic resin type selection should be referred to “TY R83-2-9002-1”.
5.11 Texture/Glossing of housing
z The texture area and texture no should follow Philips make-up sheet.
z The exterior surfaces shall have a uniform texture.
z Philips must approve the mold texturing.
z Detail document for texture refer to “UN-D249”, “UN-D 600”.
z < = 20 gloss units
5.12 Tilt and swivel base
z Tilt angle : -5 ° +2/- 0 ° (forward)
+20 °+0/-2 ° (backward)
5.13 Kensington Lock
z Must meet Kensington_slot.spec “TYE-M0004”.
z MMD request metal plate in Kinsington hole.
5.14 Label
z Regulatory label / Carton label should follow Philips requirement.
z China RoHS label
z Detail document refer to Philips Engineering Reference Book.
5.15 Product dimension / Weight (Refer to SHT 191 )
z Unit dimension : 506mm (W) * 403mm(H) * 205mm(D)
z Packed unit dimension: 570mm(W) * 124mm(H) * 453 mm(D) for WW
: 570mm(W) * 124mm(H) * 453 mm(D) for China
z Net weight : 5.0Kg (Including I/F cable 240 g)
z Gross weight : 6.2Kg for WW
: 6.2 Kg for China
http://www.wjel.net
To Next Page
Loading...
