Philips 237E4QSD/93 - Electrical Characteristics

58
Meridian 4
Active area (W x H) : 509.76(H) x 286.74(V) mm
View angle (CR>=10) : R/L 160(Typ.), U/D 160(Typ.)
Contrast ratio : 600:1(min.), 1000:1 (Typ)
White luminance : 200 cd/m2(Min.), 250 cd/m2(Typ. Center 1 point)
Color gamut : 70% (Typ.)
Gate IC : N/A
Source IC : N/A
Response time : <=5 ms (Typ)
Vertical frequency range : 50~75Hz
SEC
Type NR. : SEC LTM230HT10
Resolution : 1920 x 1080 (WSXGA+)
Outside dimensions : 534(H) x 311.7(V) Typ. x 10.7(D) Typ.
Pitch (mm) : 0.265mm x 0.265mm
Color pixel arrangement : RGB vertical stripe
Display surface : Hard coating (3H), Anti-glare treatment of the front polarizer
Color depth : 16.7M colors
Backlight : LED
Active area (W x H) : 509.76(H) x 286.74(V) mm
View angle (CR>=10) : R/L 160(Typ.), U/D 160(Typ.)
Contrast ratio : 600:1(min.), 1000:1 (Typ)
White luminance : 200 cd/m2(Min.), 250 cd/m2(Typ. Center 1 point)
Color gamut : 70% (Typ.)
Gate IC : N/A
Source IC : N/A
Response time : <=5 ms (Typ)
Vertical frequency range : 50~75Hz
Scanning frequencies
Hor. : 30 – 83 K Hz
Ver. : 56 - 76 Hz
Video dot rate: < 170 MHz for VGA and < 170 MHz for DVI
, warning message must be
displayed while over 165 MHz (supplier to provide accurate scaler bandwidth number)
Power input: 90-264 V AC, 50/60  2 Hz
Functions:
(1) D-SUB analog R/G/B separate inputs, H/V sync separated, Composite (H+V) TTL level,
(2) SOG sync : a. Sync select: H + V
b. Sync select: SERR
c.
XS SYNC SELECT: H EOR V
(3) DVI digital Panel Link TMDS inputs, HDCP supported.
Ambient temperature:
0 C - 40 C
Power Range
FULL RANGE POWER SUPPLY 90 – 264 VAC
ELECTRICAL CHARACTERISTICS
Scaler should be capable of below items.
1) Scaler must support color engine for Image enhancement feature (SmartImage)
2) Scaler must have enough memory to support PerfecTune feature and Philips OSD
3) Scaler must support SmartContras,
20M:1 DCR preferred
4) VGA signal Auto adjustment:
Monitor automatically adjusts and optimizes resolution and frequency based on input signal defined by
“Source” function. “NO VIDEO INPUT” (source)”(Note A)message to be displayed on screen while no
signal is detected. Monitor will automatically optimize resolution and frequency whenever connected to
different signal source. When press the “Auto”, the screen also show a status bar. During adjustment
period, a status bar will show on screen from 0% to 100% to indicate the progress of adjustment.
Auto auto adjustment : new timing & preset modes ( non- factory preset mode) should do auto