7
2. Setting up the monitor
2.3 Remove the Base Stand
Remove the Base Stand
Before you start disassembling the monitor base,
please follow the instructions below to avoid
damage or injury.
1. Place the monitor face on a safe surface, then
loose the screw form the base.
Physical Function
Tilt
Resolution notification
This monitor is designed for optimal performance
at its native resolution, 1920x1080@60Hz.
When the monitor is powered on at a different
resolution, an alert is displayed on screen: Use
1920x1080@60Hz for best results.
Display of the native resolution alert can be
switched off from Setup in the OSD (On Screen
Display) menu.
20˚
-5˚
2. Release the screw of base stand then pull the base
away from the monitor.
To Next Page
Loading...
