5.2.4 How to Clear the Error Buffer
The error code buffer is cleared in the following cases:
• By using the CLEAR command in the SAM menu
• By using the CLEAR command in the Factory mode:
• By using the following key sequence on the remote control transmitter: “062599” directly followed by the OK button.
• If the contents of the error buffer have not changed for 50 hours, the error buffer resets automatically.
Note: If you exit SAM by disconnecting the mains from the television set, the error buffer is not reset.
5.3 Panel Code
Press the following key sequence on a standard RC transmitter: “062598” directly followed by MENU and “xxx”, where “xxx” is a 3 digit decimal value
of the panel type: see column “Display Code” in below tab. After resetting the Display Code, restart the set immediately.
CTN_ALT BOM Panel Type Display Code
32PHD5813/55 TPT320B5-AT011H S011M 208
32PHG5813/78 TPT320B5-AT011H S011M 208
32PHG5813/77 TPT320B5-AT011H S011M 208
43PFG5813/78 TPT430H3-DUYSHA.G S1CAG 207
43PFG5813/77 TPT430H3-DUYSHA.G S1CAG 207
43PFD5813/55 TPT430H3-DUYSHA.G S1CAG 207
43PFT5813/57 TPT430H3-DUYSHA.G S1CAG 207
32PHG5833/77 TPT320B5-AT011H SV016J 208
32PHG5813/78 TPT320B5-AT011H SV016C 216
32PHG5813/77 TPT320B5-AT011H SV016C 216
43PFG5813/78_AUO TPT430H3-HVN01.U S082S 217
To Next Page
Loading...
