Philips 355 - Explicit Call Transfer

Operator services 83
a second call as described in “Make a second call”
above. When the second call is engaged, press
, and
select
Conference . Repeat the above process until five
members are connected.
If there is an incoming call during the conference call
and there are less than five members, you can accept
this new call by pressing
, . Press , again and then
select
Conference to add this member to the
conference call. If there is an incoming call during a
conference with five members already connected, you
can answer this new incoming call, but not add it to
the conference.
While a conference call is in progress, press
, to
access the
Conf. members options. Disconnect a
member of the conference by selecting
Remove party
and pressing , to confirm, or select Private call to
have a private call with this member only (other
members are put on hold).
Subscription dependent
You can connect an active call and a call on hold. You
are disconnected when the transfer is completed.
During a call press
, , select Tra ns fer and press , .
This feature is different from the Call forward, which
takes place before you pick up the call (see page 71).
Explicit call transfer