Advanced Ambilight Settings
Neutralise the influence of a coloured wall on the
Ambilight colours
(TV
menu) >
Settings > Ambilight > Advanced > Wall colour.
Select the colour of the wall behind the TV and the TV
will modify the Ambilight colours to appear as they
are intended.
ISF Tuning
(TV
menu) >
Settings > Ambilight > Advanced >
ISF tuning.
Set Ambilight to switch off immediately or slowly
fade out when you switch off the TV
(TV
menu) >
Settings > Ambilight > Advanced >
TV switch off.
13.4
Eco Settings
Set energy saving level
(TV menu) >
Settings > Eco
settings > Energy saving.
Select Maximum, Medium, or Minimum to have
different degress for energy saving, or select Off to
switch off energy saving mode.
Set screen off to save energy consumption
(TV menu) >
Settings > Eco
settings > Screen off.
Select Screen off, the TV screen is switched off, to
switch the TV screen back on, press any key on the
remote control.
Switch on built-in ambient light sensor
(TV menu) >
Settings > Eco
settings > Light sensor.
Select Light sensor, the built-in ambient light sensor
lowers the brightness of the TV screen when the
surrounding light darkens. The built-in light sensor
automatically adjusts the picture, to the lighting
conditions of the room.
Set TV switch off timer
(TV menu) >
Settings > Eco
settings > Switch off timer.
Press the arrows
(up) or
(down) to adjust the
value. The value 0 (Off) deactivates the automatic
switch off.
Select Switch off timer, the TV switches off
automatically to save energy.
* TV switches off if receiving a TV signal but you don't
press a key on the remote control during a 4 hour
period.
* TV switches off if not receivING a TV signal nor a
remote control command for 10 minutes.
* If you use the TV as a monitor or use a digital
receiver to watch TV (a Set-Top Box - STB) and you
do not use the remote control of the TV, you should
deactivate this automatic switch off, to set the value
to 0.
13.5
General Settings
EasyLink - HDMI CEC
Connect HDMI CEC-compatible devices to your TV,
you can operate them with the TV remote control.
EasyLink HDMI CEC must be switched on on the TV
and the connected device.
Switch on EasyLink
(TV menu) >
Settings > General
settings > EasyLink > EasyLink > On.
Operate HDMI CEC-compatible devices with TV
remote control
(TV menu) >
Settings > General
settings > EasyLink > EasyLink remote
control > On.
Note:
• EasyLink might not work with devices from other
brands.
• The HDMI CEC functionality has different names on
different brands. Some examples are: Anynet, Aquos
Link, Bravia Theatre Sync, Kuro Link, Simplink and
Viera Link. Not all brands are fully compatible with
EasyLink. Example HDMI CEC branding names are
51
To Next Page
Loading...
