5
Switching On and Off
5.1
On, Standby or Off
Before you switch on the TV, make sure you plugged in the
mains power in the
POWER
connector on the back of the TV.
To put the TV in Standby when the indicator light is off, press
the small joystick key on the back of the TV. The indicator will
light up.
With the TV in Standby, press
on the remote control to
switch the TV on. Alternatively, press
HOME
.
Switch back to Standby
To switch the TV to Standby, press
on the remote control.
Switch Off
To switch the TV Off, press the joystick key. The indicator light
goes off.
The TV is still connected to the mains power but consumes very
little energy.
To switch off the TV completely, disconnect the power plug.
When disconnecting the power plug, always pull the power plug,
never the cord. Ensure that you have full access to the power
plug, power cord and outlet socket at all times.
5.2
Philips Logo Brightness
You can switch off or adjust the brightness of the Philips logo on
the front of the TV.
To adjust or switch off…
1 - Press
and press
(left)
Setup
.
2 - Click
General Settings
and click
Philips Logo Brightness
.
3 - Click
Maximum
,
Medium
,
Minimum
or click
Off
to switch off
the lighting of the logo.
4 - Press
BACK
repeatedly if necessary, to close the menu.
5.3
Keys on TV
If you lost the remote control or its batteries are empty, you can
still do some basic TV operations.
To open the basic menu…
1 - With the TV switched on, press the joystick key on the back
of the TV to bring up the basic menu.
2 - Press left or right to select
Volume
,
Channel
or
Sources
. If
the TV is in Shop location, you can also select
Camera
.
3 - Press up or down to adjust the volume or tune to the next
or previous channel. Press up or down to go through the list of
sources, including the tuner selection. Press the joystick key to
slide out the camera.
4 - The menu will disappear automatically.
To switch the TV off, select
TV Off
and press the joystick key.
5.4
Sleep Timer
With the
Sleep Timer
, you can set the TV to switch to Standby
automatically after a preset time.
To set the Sleep Timer…
1 - Press
and press
(Left)
Setup
.
2 - Click
General Settings
>
Sleep Timer
. With the slider bar
you can set the time to up to 180 minutes in increments of 5
minutes. If set to 0 minutes, the Sleep Timer is switched off. You
can always switch off your TV earlier or reset the time during
the countdown.
3 - Press
BACK
repeatedly if necessary, to close the menu.
5.5
Switch Off Timer
If the TV receives a TV signal but you don't press a key on the
remote control during a 4 hour period, the TV switches of
automatically to save energy. Also, if the TV does not receive a
TV signal nor a remote control command for 10 minutes, the
TV switches off automatically.
If you use the TV as a monitor or use a digital receiver to watch
TV (a Set-Top Box - STB) and you do not use the remote
control of the TV, you should deactivate this automatic switch
off.
To deactivate the Switch Off Timer
…
22
To Next Page
Loading...
Need help?
General
Weight and Dimensions
