Philips 6000 Series - Page 14

14
English
•
Mounting of side brush, mop holder, and mop: Align the side brush with the hole at the bottom of the
main unit, press it gently, and complete the installation when you hear a "clicking" sound. To better build
a home map, before the rst use, it is recommended to remove the mop components of the main unit,
and start map building and cleaning in the cleaning mode. After initial map building and cleaning, put
back the mop components to start mopping and cleaning.
•
Power-on and charging: Note that the power switch of the main unit is located at the bottom. Before
use, move the power switch to the position "I". After power-on, short press the Recharging button of
the main unit to call the robot back to the docking station. Before the rst use, charge the main unit fully
(about 4 h) to ensure that the robot works properly. Note that the light indicator will ash white when the
main unit is in the charging state and will turn white and be always ON after full charging.
Power switch