Philips AC1711 - Storage Instructions; Troubleshooting Common Issues; Appliance Not Working or Locked; Reduced Airflow Performance

15EN
6 Storage
1 Turn o the air purier and unplug from the power socket.
2 Clean the air purier, particle sensor and the surface of the lter (see chapter
“Cleaning and maintenance”).
3 Let all parts air dry thoroughly before storing.
4 Wrap the lter in air tight plastic bags.
5 Store the air purier, lter in a cool, dry location.
6 Always thoroughly wash hands after handling the lter.
7 Troubleshooting
This chapter summarizes the most common problems you could encounter with
the appliance. If you are unable to solve the problem with the information below,
contact the Consumer Care Center in your country.
Problem Possible solution
The appliance does
not work properly.
•
The lter replacement alert has been on continuously
but you have not replaced the corresponding lter. As a
result, the appliance is now locked. In this case, replace the
lter and long touch and to reset the lter lifetime
counter.
The airow that
comes out of
the air outlet
is signicantly
weaker than
before.
•
The surface of the lter is dirty. Clean the surface of the
lter (see the chapter “Cleaning and maintenance”).
The air quality
does not improve,
even though the
appliance has been
operating for a
long time�
•
Check if the packing material is removed from the lter.
•
The lter has not been placed in the appliance. Make sure
that the lter (FY1700/30) is properly installed.
•
The particle sensor is wet. The humidity level in your room
is high and causes condensation. Make sure that the
particle sensor is clean and dry (see the chapter “Cleaning
and maintenance”).
•
Room size is large or the outdoor air quality is poor.
For optimum purication performance, please close the
doors and windows when operating the air purier.
•
There are indoor pollution resources. For instances,
smoking, cooking, incense, perfume or alcohol.
•
Filter reaches the end of life. Replace the lter with a new
one�