9EN
Using the light on/o
function
With the light on/off button, you can
switch on or off the air quality light,
the display screen and the function
indicators if needed.
1 Touch the light on/off button
once, the air quality light, the
display screen and the function
indicators will go off.
2 Touch the light on/off button
again, all lights will be on again.
Switching the display
mode
The air purifier has two display modes:
Indoor Allergen Index (IAI) display
and PM2.5 display mode. When in IAI
mode, the display shows a number
between 1-12 to indicate the level of
airbone allergens. In PM2.5 mode the
display shows the particulate matter 2.5
concentration in the air in µg/m
3
.
Note
• The air purifier operates in PM2.5
display mode by default.
1 Touch the light dimming button
for 3 seconds to switch to IAI
display mode (fig.u).
» The actual IAI level displays on
the screen.
2 Touch the light dimming button
for 3 seconds again to switch back
to PM2.5 display mode (fig.v).
» The PM2.5 level displays on the
screen.
5 Cleaning
Note
• Always unplug the appliance before
cleaning.
• Never immerse the appliance in water
or any other liquid.
• Never use abrasive, aggressive, or
flammable cleaning agents such as
bleach or alcohol to clean any part of
the appliance.
• Only the pre-filter is washable. The air
purification filter is not washable nor
vacuum cleanable.
Cleaning schedule
Frequency Cleaning method
When necessary
Wipe the surface
of the appliance
with a soft dry
cloth
When F0
displays on the
screen
Clean the pre-
filter
Every two
months
Clean the air
quality sensors
Cleaning the body of the
appliance
Regularly clean the inside and outside
of the appliance to prevent dust from
collecting.
1 Wipe away dust with a soft dry cloth
from the body of the appliance.
2 Clean the air outlet with a soft dry
cloth.
To Next Page
Loading...
