Philips AC3737 - Setting Target Humidity

9EN
Settingtargethumidity
Tap the button to set the target humidity level to 40%, 50%, 60% or ---.
» If you have not set a humidity level, the default target humidity is 50%.
» When the ambient humidity reaches the target level, the appliance will automatically switch
to the lowest fan speed. If the humidication sensor detects that the current humidity drops
below the target level, the appliance will switch back to the previous fan speed automatically.
» The "---" display indicates that no humidity is set, and the appliance will continue to humidify
the air until the RH (Relative Humidity) level reaches 70%.
» After removing the water tank, the appliance goes to the Purication ONLY mode
automatically and you can't set the humidity level. Tap the button, blinks on the screen.
Displayswitch
•
2-in-1 mode ( ): Tap the button to switch to view PM2.5 (particles smaller than 2.5 microns),
IAI (Indoor Allergen Index) and current humidity.
» The appliance displays the current humidity by default.
1 2
•
Purication ONLY mode: Tap the button to switch between PM2.5 and IAI levels.
» The appliance displays the PM2.5 level by default.