Philips AC3833 - Filter Reset; Storage

36 EN
1 Switch o the air purier and unplug from the power socket�
2 3 4 5 6
2 Pull the back cover and remove it from the appliance�
3 Pull the lter from the appliance�
4 Remove all packaging materials of the new lter�
5 Put the new lter into the appliance�
6 Reattach the back cover�
7 Put the plug of the air purier in the power socket�
8 Touch the button to switch on the appliance�
9 Touch and hold the lter status check/reset button
for 3 seconds to reset the lter lifetime counter�
10 Wash your hands thoroughly after replacing the lter�
Note: Do not smell the lter as it has collected pollutants from the air�
Filter reset
You can replace the lter even before lter replacement
alert ( ) displays on the screen� After replacing a lter,
you need to reset the lter lifetime counter manually�
1 Touch the power button for 3 seconds to turn o
the appliance and unplug from power socket�
2 Put the power plug in the power socket�
3 Within 15 seconds after power on, touch and hold
and button for 3 seconds to reset the lter lifetime counter.
6 Storage
1 Turn o the air purier and unplug from the power socket�
2 Clean the air purier, particle sensor and the surface of the lter (see
chapter ‘Cleaning and maintenance’)�
3 Let all parts air dry thoroughly before storing�
Filter
has been replaced.
PM2.5
IAI Gas
3’
+