Philips AC5659 - Manual Filter Reset

13EN
English
Note
• Wash your hands after changing a filter.
• This air purifier has no other user-
serviceable parts. For assistance,
contact the Consumer Care Center in
your country.
Filter reset
You can replace filters even if there is
no filter replacement code displayed on
the screen. After replacing a filter, you
need to reset the filter lifetime counter
manually.
1 Touch and simultaneously for
3 seconds to enter the filter reset
mode (fig.€).
» Code (A3) of the NanoProtect
filter HEPA Series 3 displays on
the screen.
2 Touch and hold for 3 seconds to
force reset the filter lifetime counter
of the NanoProtect filter HEPA
Series 3 (fig.).
3 Code (C7) of the NanoProtect
filter Active Carbon displays on the
screen after the lifetime counter of
the NanoProtect filter HEPA Series 3
has been reset (fig.‚).
4 Touch and hold for 3 seconds to
force reset the filter lifetime counter
of the NanoProtect filter Active
Carbon and exit the filter reset
mode (fig.ƒ).
Filter alert chart
Filter alert light
status
Action
A3 displays on the
screen and the
filter replacement
alert
goes on
Replace the
NanoProtect
filter HEPA Series
3 (FY5185)
C7 displays on the
screen and the
filter replacement
alert
goes on
Replace the
NanoProtect filter
Active Carbon
(FY5182)
A3 and C7 display
on the screen
alternately and the
filter replacement
alert
goes on
Replace both
filters
1 Turn off the air purifier and unplug
from the power socket.
2 Take out the used air filter according
to the filter alert light status
displayed on the screen. Discard
used filters (fig.).
Note
• Do not touch the pleated filter surface,
or smell the filters as they have
collected pollutants from the air.
3 Remove all packaging material from
the new filters (fig.f).
4 Place the new filters into the air
purifier (fig.g).
5 Put the plug of the air purifier in the
power socket.
6 Touch and hold the reset button
for 3 seconds to reset the filter
lifetime counter.