Customization
•
temperature and volume, then press the “ ” button again, the machine
will make a beep sound and the “ ” indicator will light up constantly. The
intelligent memory setup is completed.
• Press the “ ” button, the screen will display the stored water temperature
and water volume, press the safety lock button to unlock (this step is not
needed if ambient water is selected), the dispenser will extract the
customized water when you press the extraction button.
Changing water
water tank needs to be changed, which will happen in the following
conditions:
• The water level of raw water tank is under or reaches the lowest water level
• The TDS value of raw water is high
• The water in the raw water tank is not changed within 48 hours
To change the water, open the lid of the raw water tank, lift the raw water
tap water, place it back to the machine and close the lid properly.
Note: Do not add water into the raw water tank without discarding the
residual waste water.
Winter mode
• When the ambient temperature is lower than 10, winter mode can be set.
•
single use.
3s
08
To Next Page
Loading...
