Sleep mode
• If no operation in 1 minute, the dispenser will automatically go to sleep mode.
•
• Touch any button to end the sleep mode.
Boiling point calibration
3s
3s
• To prevent excess steam, the local boiling point should be checked and
for the
calibration will be completed automatically. This procedure will last for
about 60 seconds. A container with a volume not less than 500ml should be
placed under the nozzle during this procedure.
Note: There might be steam ejection during the boiling point calibration,
please be aware of burn hazards.
Removeable drip tray
• If a small cup is used, the removable drip tray can be adjusted to a higher
position by pulling it out and putting it at the higher position directly.
One-key emptying
•
are empty.
Note: In order to avoid dry-heating, after one-key emptying, please extract
some ambient water before extracting hot water.
To Next Page
Loading...
