Philips ADR610s - 4 System Setting

7
4. System setting
Press menu button to enter menu list to display system settings below.
No.
Function
Description
1
Resolution
Set resolution mode:
1080p 30fps，720p 60fps，720p 30fps.
2
Video Length
Set video clips recording time:
1 minute, 3 minutes, 5 minutes.
3
Exposure
Exposure setting.
Default “0” is automatic exposure，range can be set from -2~+2.
4
Motion Detection
In standby mode, device will start recording automatically after
detected a moving object ahead within the effective range, if
video pictures no change, it will stop recording. If the front object
move again, device will start recording again.
5
Audio Recording
Switch on/off voice recording, default is On.
6
Information Stamp
Switch on/off information stamp.
7
G-Sensor
Set G-Sensor value.
8
Device Sounds
Switch on/off button beep sound.
9
Parking mode
When device is OFF, if collision happened, it will trigger G-sensor
to start device and start up 20 seconds emergency recording
functions. If no power supplied, device will automatically shut
down after 20 seconds emergency recording. If device has power
supplied, device will enter into normal recording status after 20
seconds emergency recording.
10
Time & Date
Set system date and time.
11
Language
Language setting, default is Simplified Chinese for China
customers and English for customers outside of China.
12
Frequency
Set different scenario related frequent of luminaire, default value
is 50.
13
Screen Saver
Set screen saver time, can be set as always on or set screen saver
time, default setting is 5 minutes to enter screen saver mode.
14
Fatigue Driving
Switch on/off fatigue driving alert function.
15
Format SD Card
Format MicroSD card.
16
Default Setting
Reset all device settings to factory default settings.
17
System Info
Display firmware version information.