Philips AE 3650 - Power Failure

Power supply 9/10 kHz
AC MAINS ADAPTER (not included)
You can connect the set to the mains using a mains
adapter.
Only use a mains adapter which supplies 4,5 VDC with &
the negative pole at the centre pin of the plug.
Before connecting the mains adapter
e Check that the mains voltage indicated on the type plate of the
adapter matches your local mains voltage.
e lí the mains adapter is equipped with a voltage selector, set this to
the local voltage.
e Connect the mains adapter to the 4,5 V DC socket of the set and to
the wall socket.
POWER FAILURE
— lí the power supply is interrupted, the programmed time settings and
preset radio stations will be kept in the memory for 10 min. or more.
— lí the AC power is disconnected from the 4,5 DC socket, the
batteries (if present) will take over the supply.
9/10 kHz SELECTOR
The minimum "frequency distance” (span division) between adjacent
radio stations (measured in kHz) is standardized all over the world.
However, North and South ii use another standard than the rest
of the world.
This means that the radio should use a tuning step according to the
standard concerned in order to obtain accurate radio tuning.