To Next PageTo Next Page
Need help?Do you have a question about the Philips MX3900D and is the answer not in the manual?
Covers general electrical and physical parameters of the DVD receiver.
Outlines output power, frequency response, and input sensitivity.
Details anti-static equipment and safety precautions for handling components.
Provides warnings about electrostatic discharge sensitivity in multiple languages.
Outlines safety requirements for restoring the set to its original condition.
Step-by-step guide for removing the front panel assembly.
Provides critical safety warnings and important notes for service procedures.
Instructions to start the service test program and navigate the main menu.
Details on activating specific tests like EEPROM, Format, and Volume control.
Overview of DVD-specific tests including I2C, Version Matrix, Player, and Dealer tests.
Steps to check the current software version of the DVD matrix.
Instructions for upgrading the DVD software using a CD-ROM.
Explains the basic operation, benefits, and disadvantages of class-D amplifiers.
Details the TDA8920 function, including PWM signal conversion and servo control.
Details the functions of IC 7130, IC 7422, IC 7304, IC 7330, IC 7352, and IC 7402.
Explains line out mute, headphone amplifier, and sound feature control.
Block diagram and location of switches for the 5DTC control board.
Schematic diagram for the 5DTC control board.
Details the M29F002BT chip's logic diagram and pin functions.
Describes the M5705 chip's features, application, and interface capabilities.
Detailed description of all pins for the M5705 chip.
Internal block diagram for CS8415A and M29F800DT chips.
Schematic diagrams for the MONO-BE board (Diagram 1).
Covers general electrical and physical parameters of the DVD receiver.
Outlines output power, frequency response, and input sensitivity.
Details anti-static equipment and safety precautions for handling components.
Provides warnings about electrostatic discharge sensitivity in multiple languages.
Outlines safety requirements for restoring the set to its original condition.
Step-by-step guide for removing the front panel assembly.
Provides critical safety warnings and important notes for service procedures.
Instructions to start the service test program and navigate the main menu.
Details on activating specific tests like EEPROM, Format, and Volume control.
Overview of DVD-specific tests including I2C, Version Matrix, Player, and Dealer tests.
Steps to check the current software version of the DVD matrix.
Instructions for upgrading the DVD software using a CD-ROM.
Explains the basic operation, benefits, and disadvantages of class-D amplifiers.
Details the TDA8920 function, including PWM signal conversion and servo control.
Details the functions of IC 7130, IC 7422, IC 7304, IC 7330, IC 7352, and IC 7402.
Explains line out mute, headphone amplifier, and sound feature control.
Block diagram and location of switches for the 5DTC control board.
Schematic diagram for the 5DTC control board.
Details the M29F002BT chip's logic diagram and pin functions.
Describes the M5705 chip's features, application, and interface capabilities.
Detailed description of all pins for the M5705 chip.
Internal block diagram for CS8415A and M29F800DT chips.
Schematic diagrams for the MONO-BE board (Diagram 1).
Power| power requirement | 120V, 60Hz |
|---|---|
| power consumption | 150 watts |
| standby power | <20 watts |
Loudspeakers| speaker frequency range | 120Hz~20kHz |
|---|---|
| speaker impedance | 4 Ω |
| subwoofer frequency range | 30Hz~120Hz |
Amplifier| amplifier type | Full Digital 6-channel Class-D™ |
|---|---|
| amplifier power per channel | 6 x 85 watts RMS |
| total power | 500 watts |
Video Performance| progressive scan | Yes |
|---|---|
| video upsampling | 27MHz/10bit |
| video system | Multi (NTSC/PAL) |
Audio Performance| audio DAC | 24 bit, 96 kHz |
|---|---|
| signal to noise ratio | >65 dB |
| frequency response | 30 Hz - 30 kHz |
Weight and Dimensions| product dimensions (DVD system) | 17.1" W x 3.8" H x 14.1" D |
|---|---|
| product dimensions (satellite speaker) | 3.7" W x 6.1" H x 3.5" D |
| product dimensions (subwoofer) | 7.7" W x 17.0" H x 15.4" D |
