PHILIPS ANDERIC Master
Introduction
We want to thank you for purchasing this Universal Hospitality remote by Anderic®. With the purchase of this remote
you should receive a screw for the battery cover. Battery cover screw is optional; battery cover does not need screw
to hold it in place. This remote requires two AAA size batteries, not included.
Optional Security Cable Attachment
Optional Security Cable available from anderic.com, Part number: CBL01. This cable easily adheres under the
battery cover for a secure and flush appearance.
Pre-programmed Codes
This remote is pre-programmed by default to LG and VIZIO TVs under TV mode and DirecTv under STB Mode (Set-
Top-Box). If the TV or STB is not one of the brands above, you must program the remote using the directions below:
NOTE: If [S] key is not present on your remote, note that it is the unmarked button to the right of the
[POWER] key.
Programming the remote: Direct Code Input Method
1. Turn on the device you want to control, and find the corresponding brand code from attached code list.
2. Press and release the device mode key you would like to program ([TV] or [STB]).
3. Press and hold [S] and [ENTER] keys simultaneously for about three seconds until indicator light lights and
remains on, release both keys.
4. Input the four digits code. If remote successfully saved code, indicator light will go out. If error, indicator light will
blink slowly three times and go out, repeat steps 1-4.
a. Check if most keys of remote control can control the device, if not, please restart step 1-4 using a different
code.
b. After trying all codes for your brand without success, please try “Programming the remote – Code Search”
To Next Page
Loading...
