Philips ANDERIC Master - Programming the remote: Code Search Method; Code Display; Single Press Combined POWER Key

method below.
Note: During the programming mode, pressing any button other than number buttons or not pressing any button for
10 seconds will cause remote to exit programming mode.
Programming the remote: Code Search Method
Note: use this method if your brand is not listed in the codes attached, or if all the codes you tried does not work.
This method scans through each code in the database.
Manual search
1. Turn on the device you want to control.
2. Press and release the device mode key you would like to program ([TV] or [STB]).
3. Press and hold [S] and [ENTER] keys simultaneously for about three seconds until indicator light lights and
remains on, release both keys.
4. Repeatedly Press [CH+] to search forwards or [CH-] to search backwards; remote will send the code of
POWER one by one.
5. When device is turned off, immediately press [S] button to save and exit. Check if most keys of remote can
control the device, if not, please restart from step 1, remote will pick up where it left off in code database.
Auto search
1. Turn on the device you want to control.
2. Press and release the device mode key you would like to program ([TV] or [STB]).
3. Press and hold [S] and [ENTER] keys simultaneously for about three seconds until indicator light lights and
remains on, release both keys.
4. Press and release [POWER] key, mode indicator light will blink one time and continue to blink every 2 seconds.
Remote is sending codes of POWER one by one. If to press [CH+] / [CH-] can change the searching direction.
5. When device is turned off, immediately press [S] button to save and exit. Check if most keys of remote can
control the device, if not, please restart from step 1, remote will pick up where it left off in code database.
Code Display
About: use this method to display the code that is currently programmed.
1. Press and release the device mode key ([TV] or [STB]) in which you want to display programmed code for, then
follow steps below:
a. Press and release keys [MUTE] and [1] simultaneously, then release. The LED flashing times represents the
first digit of code. Note: If digit is 0, the LED will not flash.
b. Press and release keys [MUTE] and [2] simultaneously, then release. The LED flashing times represents the
second digit of code.
c. Press and release keys [MUTE] and [3] simultaneously, then release. The LED flashing times represents the
third digit of code.
d. Press and release keys [MUTE] and [4] simultaneously, then release. The LED flashing times represents the
fourth digit of code.
Note: If digit is 0, the LED will not flash.
Single Press Combined POWER Key
About: This allows for powering on/off both your TV and STB (Set-top-box) with one press of the [POWER] button. If
enabled, pressing [POWER] key will send code for power for both units. If disabled, pressing [POWER] key will only
send code for TV. See steps below.
1. Press and hold [S] and [ENTER] keys simultaneously for about three seconds until indicator light lights and
remains on, release both keys.
2. Device mode indicator light will light. It doesn’t matter which mode lights.
3. Input code [9] [9] [9] [5].
a. Enabled – (0 blinks): If LED turns off directly after inputting the four digits, this indicates that “one key power-
off all devices” was successfully Enabled;