3. Press the button you want to unlock the punch-through, the LED will blink one time & turn off.
Device Mode Lock
About: This is used to lock the code for the device so they cannot be re-programmed. After device is locked, the
current code cannot be changed, and any other operation is invalid unless you repeat steps 1- m3 to unlock first.
1. Press and release the device mode key you would like to lock code for ([TV] or [STB]).
2. Press and hold [S] and [ENTER] keys simultaneously for about three seconds until indicator light lights and
remains on, release both keys.
3. Input code [9] [9] [9] [9],
a. Locked – If LED turns off directly after 4 digits input, it indicates mode successfully locked.
b. Unlocked – If LED blinks 2 times and turns off after 4 digits input, it indicates mode successfully unlocked.
Reset to Factory Default Status
1. Press and hold [S] and [ENTER] keys simultaneously for about three seconds until indicator light lights and
remains on, release both keys.
2. Input code [9] [7] [6] [0]. Indicator light will turn off, indicating that the remote has been reset to factory default
status.
Advanced Option: Shift remote to 1-Device; TV only remote.
Note: This feature allows remote to switch from a 2-Device remote to a 1-Device; TV only remote. STB mode will be
deactivated. Remote will be reset to factory defaults for 1-Device.
1. Press and hold [S] and [ENTER] keys simultaneously for about three seconds until indicator light lights and
remains on, release both keys.
2. Input code [9] [7] [6] [1]. Indicator light will blink 3 times, indicating that the remote has successfully been reset
to factory default status and converted to a 1-Device remote.
Advanced Option: Shift remote to 2-Device; TV/STB remote.
Note: This feature allows remote to switch from a 1-Device remote to a 2-Device; TV and STB enabled remote. Both
modes will be activated. Remote will be reset to factory defaults for 2-Device.
1. Press and hold [S] and [ENTER] keys simultaneously for about three seconds until indicator light lights and
remains on, release both keys.
2. Input code [9] [7] [6] [2]. Indicator light will blink 3 times, indicating that the remote has successfully been reset
to factory default status and converted to a 2-Device remote.
LEGAL: Anderic® is a registered trademark of Dan’s Electronics Etc., Inc. All rights reserved. This document is
copyrighted.
TV CODES
Admiral 1917 1927
Advent 1933
Akai 1930 1939 1999 2025
AOC 1964 1985 2029 2032 2073
To Next Page
Loading...
