Philips AVENT SCD845 - VOX mode operation

- 16 -
Note: The link light shows that the parent unit is still on and connected
to the baby unit�
Note: When sensitivity level is not set to 'very high', low sounds will be
muted�
Note: Set the sensitivity level to 'very high' to have continuous sound
on the parent unit� Please see the Sensitivity level chapter for more
information�
All sounds are constantly transmitted to the parent unit� If your baby
cries, the display of the parent unit is still o, but the sound level
lights light up green and the sounds detected by thebaby unitare
transmitted to the parent unit. As long as no sound is detected, the
sound level lights are o.
VOX mode
1 Press the mode button on the side of the parent unit to switch to VOX
mode�
Note: When the display is on, the selected mode is shown in the status
bar. The status baris not visible when the display is o.
When the VOX mode is activated, the display and sound of the parent
unit switch o, if there is no sound detected for 20 seconds.
Whensound is picked up by the baby unit, the displayand sound of
the parent unit switch on immediately.The sounds are transmitted to
the parent unit and the sound level lights light up green� As long as no
sound is detected, the sound level lights are o.
Note: The minimum sound level to activate sound and display is
dened by the sensitivity setting.
20°C
1
AUDIO
VOX
VOX
VOX
VOX
VOX
20°C
1
VOX
20°C
1
VOX