Philips AZ 1508 - Power Supply Options; Battery Installation and Safety; Connecting to Mains Power

POWER SUPPLY
Batteries
For the set (optional):
Open the battery compartment of the set and insert six batteries,
type R20, UM1 or D-cells (preferably alkaline).
For the remote control (supplied):
Open the battery compartment of the remote control and insert two
batteries, type R06, UM3 or AA-cells (preferably alkaline).
Remove the batteries if they are flat or the set is not going to be
used for a long time.
Batteries contain chemical substances, therefore they
should be disposed of properly.
Mains
1
Check whether the mains voltage as shown on the type plate
corresponds to your local mains voltage. If it does not, consult
your dealer or service organisation. The type plate is located
on the base of the set
If the set is equipped with a VOLTAGE selector (x), set this
selector to the local mains voltage.
2 Connect the mains cable to the AC MAINS inlet and the wail
socket. This switches on the mains supply. The mains cable is
inside the battery compartment
The battery supply will be switched off when the set is connected
to the mains. To change over to battery supply, pull out the plug
from the unit's AC MAINS socket.
To disconnect the set from the mains completely, remove the mains
plug from the wall socket.
For users in the UX: please follow the instructions on page 2.
To avoid overheating of the set a safety circuit has been built in. Therefore your
set may switch off under extreme conditions. If this happens, release the
POWER button and let the set cool down before reusing it.
7
English