CD PLAYER
17
AZ 6000/05 page 17
You can store up to 20 tracks in the desired sequence. If you like, store
any track more than once.
1. In the stop position, press PROG to activate programming.
= Display shows Tr1 P-01, indicating the start of the
program. appears.
2. Press ∞ or § (on the remote control ¡ or ™) to select your desired
track number.
3. Press PROG to store your desired track number in the 1st program
location.
= Display: the track number and P-01.
4. Repeat steps 2-3 to select and store all desired tracks.
= Display: if you try to program more than 20 tracks.
5. To play your program, press
PLAY/PAUSE 2;
.
Helpful hints:
- During programming,
if no action is executed within 10 seconds,
will appear and programming stops automatically. To
resume programming, press
PROG.
Reviewing the program
After appears, you can review all the songs you have programmed in the program stop
position.
• If necessary, press
9
to enter the stop position.
•Press and hold PROG until the display shows all your stored track numbers in sequence.
Erasing a program
You can erase the contents of the memory by:
• opening the CD door;
•pressing
9
twice during playback
•pressing
9
once after appears.
= is displayed briefly and disappears.
PROGRAMMING TRACK NUMBERS
To Next Page
Loading...
