TROUBLESHOOTING
19
English
AZ 6000/05 page 19
– Problem • Solution
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
Remote control does not function properly
– Batteries exhausted/ incorrectly inserted
• Insert (fresh) batteries correctly
– Distance/ angle between the set too large
• Reduce the distance/ angle
–Your desired sound source is not selected
• Make sure you select your desired sound
source before operating keys on the remote
control.
No sound /power
–Volume not adjusted
• Adjust the VOLUME
– MUTE is active
• Switch off MUTE
– Power cord not securely connected
• Connect the AC mains lead properly
– Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
– Headphones connected to the set
• Disconnect headphones
– External audio appliance connected to the set
• Disconnect the LINE-IN audio cable
indication
–You may have moved to a new area which is
blocking the range of DAB transmitter.
• Autoscan the full range of DAB and refresh the
list of stations in service (See Chapter DAB,
TUNING/RETUNING, Autoscan Full)
• Move to another location to find better DAB
reception
/ indication
– The station is out of service.
•The set will retune to an alternative service .
– The retuning fails.
• Reset your DAB radio to reset the list of
available stations (See Chapter DAB,
Resetting)
Severe radio hum or noise
– Electrical interference: set too close to TV, VCR
or computer
• Increase the distance
Poor radio reception
–Weak radio signal
• Adjust the telescopic aerial
/
indication
– No CD inserted
• Insert a suitable disc
– CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
– Laser lens steamed up
•Wait until lens has cleared
– CD-R(W) is blank/ not finalized
• Use a finalized CD-R(W)
indication
– CD-ROM disc inserted/
CD contains non-audio files
• Use CD Audio discs only/
press ∞ or § (or on the remote control ¡ or
™) once or more to skip to a CD audio track
instead of the data files
The CD skips tracks
– CD damaged or dirty
• Replace or clean CD
– SHUFFLE or PROGRAM is active
• Switch off SHUFFLE / PROGRAM
To Next Page
Loading...
