2
• Adjusting the environment light-
ing similar to that of your screen
brightness, avoid the uorescent
lighting, and surfaces that don’t
reect too much light.
• Seeing a doctor if your symp-
toms.
• The USB Type-C port could only be
connected to specify equipment
with fire enclosure in compliance
with IEC 62368-1 or IEC 60950-1.
Maintenance
• To protect your display from
possible damage, do not put
excessive pressure on the LCD
panel. When moving your display,
grasp the frame to lift; do not lift
the display by placing your hand or
fingers on the LCD panel.
• Unplug the display if you are not
going to use it for an extensive
period of time.
• Unplug the display if you need to
clean it with a slightly damp cloth.
The screen may be wiped with a
dry cloth when the power is off.
However, never use organic solvent,
such as, alcohol, or ammonia-based
liquids to clean your display.
• To avoid the risk of shock or
permanent damage to the set, do
not expose the display to dust,
rain, water, or excessive moisture
environment.
• If your display gets wet, wipe it with
dry cloth as soon as possible.
• If foreign substance or water gets in
your display, please turn the power
off immediately and disconnect
the power cord. Then, remove the
foreign substance or water, and
send it to the maintenance center.
• Do not store or use the display in
locations exposed to heat, direct
sunlight or extreme cold.
• In order to maintain the best
performance of your display and use
it for a longer lifetime, please use
the display in a location that falls
within the following temperature
and humidity ranges.
• Temperature: 0-40°C 32-104°F
• Humidity: 20-80% RH
Important information for Burn-in/
Ghost image
• Always activate a moving screen
saver program when you leave
your display unattended. Always
activate a periodic screen refresh
application if your display will
display unchanging static content.
Uninterrupted display of still or
static images over an extended
period may cause “burn in”, also
known as “after-imaging” or “ghost
imaging”, on your screen.
• “Burn-in”, “after-imaging”, or
“ghost imaging” is a well-known
phenomenon in LCD panel
technology. In most cases, the
“burned in” or “after-imaging” or
“ghost imaging” will disappear
gradually over a period of time after
the power has been switched off.
Warning
Failure to activate a screen saver, or
a periodic screen refresh application
may result in severe “burn-in” or “after-
image” or “ghost image” symptoms
that will not disappear and cannot be
repaired. The damage mentioned above
is not covered under your warranty.
Service
• The casing cover should be opened
only by qualified service personnel.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
