Philips CD911 - Technical Specifications

TECHNICAL SPECIFICATIONS
General
CD911/00S
CD921/17S8
1.Mains voltage
2.Mains frequency
3.Mains voltage selection
4.Power consumption mains, standby
Remote Control
A. Internal: RC5(only CD921)
B. External: ESI
V-in Low
V-in High
R-in
Specification:
Line output
1.Number of channels
2.Output voltage
3.Unbalance left-right
4.Output resistance
5.Amplitude tinearity
6.Phase non-linearity
7.Signal to noise ratio
8.Dynamic range (-60 dB)
9.Total harmonic distortion + noise
10.Intermodulation distortion
11.Out-band attenuation
12.Channel separation
13.Automatic switched deemphasis with time constant 15/50 us
14.Non linearity at -90 dB
Variable headphone (low end)
1.Output voltage
2.Unbalance left-right
3.Output resistance
4.Load impedance range
5.Output power
Audio specs in case of 600 load at 4 Vrms voltage output
6.Signal to noise ratio
7.Dynamic range
8.Total harmonic distortion
9.Channel separation
Dimensions and weight
1.Apparatus tray closed
2.Apparatus tray open
3.Weight
Optical read-out system
1.Laser type
2.Wavelength
3.Light output (c.w.)
PCS 60 751
:2
: 2Vrms + 2 dB
: max. 1 dB
: 1kQ
: max. + 0.3 dB from 20 Hz to 20 kHz
: max 7.0° from 20 Hz to 16 kHz
:m
:m
: min. 80 dB from 20 Hz to 20 kHz
: min. 70 dB from 20 Hz to 20 kHz
: min. 35 dB (above 40 kHz)
: min. 80 dB from 20 Hz to 20 kHz
: 230V (+6 -10%)
: 117V (410%)
: 50-60 Hz
: No
: << 3W
: from -2.0 V to +1.6 V
: from +3 V to +7.5 V
: from 47 kQ to 68 kQ {
encnecnseetetlin,
n. 95 dB from 20 Hz to 20 kHz
n. 85 dB from 20 Hz to 20 kHz
:+2dB
: typ. 0 dB
: max. 5 Vrms + 3dB
: max. + 1.2dB :
: 120 Q
: 32 Q to 600 Q load
: 0 to 30 mW into 30 Q load
: 0 to 50 mW into 150 Q load
: 0 to 30 mW into 600 Q load
: typ. 80 dB
: min. 70 dB (20 Hz -20 kHz)
:m
:m
7m
in. 60 dB (20 Hz - 20 kHz)
in. 70 dB (1 kHz)
in. 65 dB (31.5 Hz - 16 kHz)
: WxDxH 435 x 300 x 90/106 mm
: WxDxH 435 x 445 x 90/106 mm
:4kg
: Semiconductor AlGaAs
: 780 nm + 20 nm (
: max. 0.5 mW