Philips DCM580 - Radio Operation; Tuning and Station Selection; Program Radio Stations

15
Program radio stations
manually
Note
You can program a maximum of 20 preset 
radio stations.
1 Tune to a radio station.
2 Press PROG/CLOCK to activate
program mode.
[PROG] (program) blinks on the »
display.
3 Press / to allocate a number (1 to 20)
to this radio station, then press PROG/
CLOCKWRFRQÀUP
The preset number and the frequency »
of the preset station are displayed.
4 Repeat the above steps to program other
stations.
Note
To overwrite a programmed station, store 
another station in its place.
Select a preset radio station
1
In tuner mode, press / to select a
preset number.
8 Listen to the
radio
Tune to a radio station
Tip
For optimal FM reception, fully extend and 
adjust the position of the FM antenna.
1 Press TUNER to select the tuner source.
2 Press and hold / for more than 2
seconds.
[SEARCH] (search) is displayed.»
The radio tunes to a station with »
strong reception automatically.
3 Repeat step 2 to tune to more stations.
To tune to a weak station, press 
/ UHSHDWHGO\XQWLO\RXÀQGRSWLPDO
reception.
Program radio stations
automatically
Note
You can program a maximum of 20 preset 
radio stations.
1 In tuner mode, press and hold PROG/
CLOCK for 2 seconds to activate
automatic program mode.
[AUTO] (auto) is displayed.»
All available stations are programmed »
in the order of waveband reception
strength.
7KHÀUVWSURJUDPPHGUDGLRVWDWLRQLV»
broadcast automatically.
English
EN