EasyManua.ls Logo

Philips DECT 629 - Telephone Troubleshooting; Handset Not Scrolling on Base; No Dial Tone Troubleshooting; No Ring Tone Troubleshooting

Philips DECT 629
58 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting
54
Troubleshooting
The icon does not scroll
when the handset is placed
on the base
PROBLEMS
No dialling tone
- Crackling on the line
The handset displays ‘not
available’
- when attempting to add
another handset to the base
station
- when using a handset
Noise interference on your
radio or television
Caller Line Identification
(CLI) service does not work
No ring tone
The icon does not appear
The icon is blinking
- Bad battery contact
- Dirty contact
- Battery is full
CAUSES
- No power
- Batteries are empty
- You are too far from the base station
- Wrong line cable
- Line adaptor (when needed) not
connected to the line cord
- The ring tone is deactivated
- No mains power
- The handset is too far from the
base station
- Handset not registered to the
base station
- You are too far from the base
station
- The base station is too close to
electrical appliances, reinforced
concrete walls or metal
doorframes
- The procedure to add a handset
has failed, try again
- Maximum number of handsets (5)
has been reached
- Base station is already busy with
another handset
The DECT 623/627 base station or
mains power pack are too close to
electrical appliances
- The service is not activated
- Move the handset slightly
- Clean the contact with a cloth
moistened with alcohol
- No need to charge
SOLUTIONS
- Check the connections. Reset
the phone : unplug and plug back
in the mains
- Charge the batteries at least
24 hours
- Move closer to the base
station
- Always use the line cable
provided
- Connect the line adaptor
(when needed) to the line cord
- Increase the volume (page 38)
- Check connections
- Move closer to the base
station
- Register the handset to the
base (page 43)
- Move closer to the base
station
- Move the base station to find a
better place (the higher the
better)
- Disconnect and connect the
base station power supply.
- Remove and place back the
handset battery
- Follow the procedure to
register a handset (page 43)
- Unregister a handset
- Wait until it is available
Move the power pack or base
station as far away as possible
- Check your subscription with
your network operator
Telephone troubleshooting
www.philips.com/support
A phonebook entry cannot
be stored
The phonebook is full Delete an entry to free memory
DECT623_627_GBIE_part2.qxd 14.07.2005 16:06 Seite 54

Related product manuals