How to connect a plug
The wires in the mains lead are coloured with the following code:
blue = neutral (N), brown = live (L).
As these colours may not correspond with the colour markings
identifying the terminals in your plug, proceed as follows:
Connect the blue wire to the terminal marked N or coloured •
black.
Connect the brown wire to the terminal marked L or •
coloured red.
Do not connect either wire to the earth terminal in the plug, •
marked E (or
) or coloured green (or green and yellow).
Before replacing the plug cover, make certain that the cord grip is
clamped over the sheath of the lead - not simply over the two wires.
Copyright in the U.K.
Recording and playback of material may require consent. see Copyright
Act 1956 and The performer’s Protection Acts 1958 to 1972.
Warning
Where the MAINS plug or an appliance coupler is used as the •
disconnect device, the disconnect device shall remain readily
operable.
Warning
Never remove the casing of this apparatus. •
Never lubricate any part of this apparatus. •
Never place this apparatus on other electrical equipment. •
Keep this apparatus away from direct sunlight, naked ames or heat. •
Ensure that you always have easy access to the power cord, plug or •
adaptor to disconnect the apparatus from the power.
English
EN
To Next Page
Loading...
