Philips DTM5095 - Play; Play from disc; Play iPod;iPhone;iPad

10 EN
» The hour digits are displayed and begin
to blink.
3 Press / to set the hour, and then
press PROG/CLOCK SET.
» The minute digits are displayed and
begin to blink.
4 Press / to set the minute.
5 Press PROG/CLOCK SET to conrm.
Turn on
Press .
» The unit switches to the last selected
source.
Switch to standby
Press again to switch the unit to standby
mode.
» The backlight on the display panel is
reduced.
» The clock (if set) appears on the
display panel.
To switch to Eco power standby mode:
Press and hold for more than two seconds.
» The backlight on the display panel
turns off.
To switch between normal standby mode and
Eco power standby mode:
Press and hold for more than two seconds.
Note
• If no button is pressed over 15 minutes in standby
mode, this device goes to Eco power standby mode
automatically.
4 Play
Play from disc
1 Press CD/ID3on the remote control or
tap SRC repeatedly on the main unit to
select CD source.
2 Insert a disc into the disc compartment
with the printed side facing right.
» The le starts playing automatically. If
not, press .
• Press EJECT to take the disc out of
the disc tray.
Play iPod/iPhone/iPad
You can enjoy audio from iPod/iPhone/iPad
through this docking system.