English
28
Before Operation (Continued)
VCR Record System
Your video recorder uses triple colour standards, PAL,
MESECAM and SECAM-L. During recording your video
recorder should select the colour system automatically,
however if you experience problems you may need to
do it manually.
DV Record Audio
You need to set this if you have a camcorder using
32kHz/12-bit sound connected to the front panel DV IN
jack.
Some digital camcorders have two stereo tracks for
audio. One is recorded at the time of shooting; the other
is for overdubbing after shooting.
On the Audio 1 setting, the sound that was recorded
while shooting is used.
On the Audio 2 setting, the overdubbed sound is used.
Auto Chapter
When recording, chapter markers are put in specified
setting. You can change this interval to 5 minutes, or
10 minutes. If you select None, switch off automatic
chapter marking altogether with the No Separation set-
ting.
DISC
Initialize
If you load a completely blank disc, the recorder will ini-
tialize the disc.
DVD+R: The Initialize menu will appears. Select “OK”
then press OK.
DVD+RW: The recorder initialize the disc to DVD+RW
mode.
Also, you can format the disc from the Setup menu as
below.
11
Press SYSTEM MENU.
The Setup menu appears.
22
Use v / V to select the DISC option.
33
While the DISC option is selected, press B to
move to the second level.
44
Use v / V to select the Initialize option.
55
Press B to move to the third level.
Start icon is highlighted.
66
Press OK.
Initialize menu appears.
77
Use b / B to select “OK” then press OK.
It takes a few moments to format the disc.
Caution
If you want to change the disc format, everything
recorded on the disc will be erased.
To Next Page
Loading...
Need help?
Operating Environment
Power
Weight and Dimensions
