Philips DVT2050/00 - 9.3.2 AUTO-OFF; 9.3.3 Enabling;disabling key and signal tones

34 Settings
21
Press + / – to set the minutes.
22
Press the record key g to confirm.
23
Press the j key to exit the menu.
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.
9.3.2 AUTO-OFF
The device switches o automatically if no key is pressed within a pre-
set period of time. This saves power.
1
In stop mode (start-up screen), press the menu key.
2
Press h / b to select the device settings menu Õ.
3
Press the record key g to confirm.
4
Press + / – to select the Auto off function.
5
Press the record key g to confirm.
6
Press + / – to specify whether the device should turn o
automatically after 5, 15, 30 or 60 minutes' inactivity.
7
Press the record key g to confirm.
8
Press the j key to exit the menu.
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.
9.3.3 Enabling/disabling key and signal tones
1
In stop mode (start-up screen), press the menu key.
2
Press h / b to select the device settings menu Õ.
3
Press the record key g to confirm.
4
Press + / – to select the Device sounds function.
5
Press the record key g to confirm.
6
Press + / – to enable/disable the key and signal tones.
7
Press the record key g to confirm.
8
Press the j key to exit the menu.
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.