Philips E Series - CMND & Play

65BDL4052E/75BDL4052E/86BDL4052E
40
Step 2. Copy pdfplaylistX.txt to “philips” folder of internal
storage. You may use FTP to do this.
- File path : /storage/emulated/legacy/philips (for DL,
PL)
Ex. /storage/emulated/legacy/philips/pdfplaylist1.txt
Step 3. Prepare the PDF les in “PDF” folder which is
under “Philips” folder of your internal storage.
- Ex. /storage/emulated/legacy/philips/pdf/xxx.pdf
/storage/emulated/legacy/philips/pdf/yyy.pdf
/storage/emulated/legacy/philips/pdf/zzz.pdf
Step 4. Start the PDF player App, it will import the text le
of PDF player automatically.
Note: Once the playlist le (text) is imported, any changes
made through the remote control will not be recorded in
the playlist text le.
Media Hotkey:
Play: Playback le.
Pause: Pause playback.
Fast forward: go to the next page. If the page is at end of
the le, it will go to the next le.
Rewind: back to the last page. If the page is at beginning
of the le, it will to back to the last le.
Stop: Return to the rst page of le.
Arrow keys:
Left: go to the previous page.
Right: go to the next page.
Combination key:
Number key + OK key: change to a specic page.
- Press number key to select a specic page.
- Press “OK” key. Page number will display at the bottom
of the page. If the page number you selected exceeds
total page number, then that page will not be changed,
but display current page number instead.
Note:
If you plug in two or more USB disks to edit the playlist,
playback from the playlist cannot be guaranteed after
powering on/o, due to the USB storage path may be
changed. It is strongly recommended to use only one USB
disk when editing the playlist.
5.7. CMND & Play
1) Server
Setup CMND & Play server address
2) Account
Setup CMND & Play account
3) PIN Code
Setup CMND & Play PIN code
(4) Version
There are two options, Ver.2 and Ver.3
Ver. 2
use 2.0/2.2 agreement
Ver. 3
use 3.0/3.1 agreement
(5) Content
There are 3 options available: internal storage, SD card
and USB storage.
If Ver.2, is selected, Server/Account/PIN code will be
shown in gray and cannot be set.