Philips FR 940 - Other Possibilities

OTHER POSSIBILITIES
SYSTEM ASPECTS
SLEEP
The sleep timer can be used to set a time period after which
you wish your system to be switched to standby mode.
e Press the SLEEP key (22).
¢ The display shows the indication SLEEP and the message
is means that the system will be switched to standby
after 90 minutes.
¢ Every time you press the SLEEP key again (within 4
seconds) the period will be decreased by 15 minutes
Wi —> HE NM -—> SO MM
e When the SLEEP key (22) is pres
position the display will show 3.
indication does not light up anymore.
‘the 15 minutes
“ and the SLEEP
Notes: ‘
e During an active sleep timer period, you can reset the time to
SQ) MM again by pressing the SLEEP key (22).
eA sleep timer period will be cancelled when you switch your
system to standby (with the standby key on your remote
control).
DEMO MODE
e By pressing and holding the SLEEP key down for more than
3 seconds you can start a demonstration program.
(When the SLEEP key (22) is pressed the receiver will first
switch to the sleep mode and after 3 seconds to demo
mode.)
¢ Several features of your receiver will now be shown one
after another on the display (and on the volume control).
¢ The demo mode can be stopped:
— by pressing the SLEEP key (22) again
~ by switching your receiver off with the POWER
STANDBY/OFF key (1)
— or by switching to standby with the STANDBY key on your
remote control.
ENHANCED SYSTEM INTELLIGENCE
If you have connected equipment to your receiver via the
ESI sockets and when AUTO SELECT (21) is activated,
there will be an additional internal communication between
the different elements in your system.
The whole system can be operated by the system remote
control.through the.sensor of the receiver.
in addition, the functions AUTOMATIC SOURCE SELEC-
TION and AUTOMATIC STOP as mentioned below are then
accessible:
: IMPORTANT:
All products of the Philips 900 series’which are equipped
with their own.remote.control, also have an IR SENSOR
ON/OFF switch.on the. back of-the unit.
When these units are incorporated.in your HiFi system with
an ESI BUS connection, this IR SENSOR ENGEF switch
should always be in the OFF position.
The product can then be operated with the remote control
of your FR940 receiver:
When these units. are‘not used in a HiFi system the switch
should be in the ON position: »
Make sure that the respective unit is switched off when |
switching the IR SENSOR.on and off.
AUTOMATIC SOURCE SELECTION
Equipment connected via the ES] sockets to the receiver is
automatically selected as the source by pressing any button
that activates the play functionon the external equipment (e.g.
PLAY, SCAN, PRESET).
Example: |f you press the PLAY key on your CD (Compact
Disc) while listening to your tuner, the source CD will be
selected.
AUTOMATIC STOP
When the selected source is in the play mode, it will always be
stopped automatically as soon as another source is selected.
Example: lf you select TUNER with the SOURCE SELECT
knob (3) while listening to your CD, the CD player will be
stopped.
11