Philips FR740 - Source Selection; Using the SOURCE SELECTOR; 6 CHANNEL; DVD INPUT Usage

16
English
SOURCE SELECTION
When selecting a source by turning SOURCE SELECTOR,
the audio inputs – and video inputs (FR 760 only) – with the
corresponding name are activated. The incoming signal is
reproduced by all audio and – if the source includes a video
signal – video outputs of the receiver.
Source selected........Connectors used
6 CH / DVD...................6 CHANNEL / DVD INPUT audio input
and DVD IN video input (FR 760 only)
TUNER ..........................The tuner part of the receiver is used,
all inputs are switched off.
CD.................................CD IN audio input
CDR/TAPE.....................CDR/TAPE IN audio input
TV..................................TV IN audio input and
TV IN video input (FR 760 only)
VCR...............................VCR IN audio input and
VCR IN video input (FR 760 only)
The 6 CHANNEL / DVD INPUT can be used to connect a
device with a built-in multichannel decoder (e.g. Dolby Digital,
DTS, etc.) and 6-channel output connector, i. e. a high end
DVD player.
When using the 6 CHANNEL / DVD INPUT audio input, the
receiver works as a multichannel amplifier. The source
reproduces surround sound and sends it to the receiver
divided into the necessary channels. Therefore the
SURROUND ON/OFF, HALL and SURR. MODE button have no
effect since the provided signal is already multichannel.
From a source which is connected to the
6 CHANNEL / DVD INPUT audio input cannot be recorded.
About 6 CHANNEL / DVD INPUT
SOURCE SELECTOR