English
19
Radio Reception
Tuning to radio stations
1
Press TUNER.
➜ "FM" or “AM” is displayed. A few seconds later,
the current radio frequency will appear on the
display.
2 Press TUNER again to select the desired
waveband : FM or AM.
3 Hold S / T (or ALBUM +/- (à / á)
on the remote control) and then release the
button.
➜ The system will start searching for a radio
station with sufficient signal strength.
4 Repeat step 3 if necessary until you find the
desired station.
● To tune to a weak station, press S / T (or
ALBUM +/- (à / á) on the remote control)
briefly and repeatedly until you have found
optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations
in the memory.
Automatic programming
1 Press TUNER to select TUNER mode.
2 Press and hold PROG/CLOCK (or
PROGRAM on the remote control) until
"AUTO" is displayed.
➜ PROG starts flashing.
➜ AUTO is displayed and available stations are
programmed in order of waveband reception
strength.
➜ When all the available radio stations are
stored or the memory for 40 presets are used,
the first preset radio station will be played.
To stop storing the automatic preset
● Press Ç.
FWM996_85_Eng 9/18/08, 16:1119
To Next Page
Loading...
