Philips FWM996 - Manual Programming; Tuning to Preset Radio Stations; Changing Tuning Grid

English
20
Manual programming
1 Tune to your desired radio station (refer to
“Tuning to radio stations”).
2 Press PROG/CLOCK (or PROGRAM on
the remote control).
➜ PROG starts flashing.
➜ The next available preset number is displayed
for selection.
To store the radio station to another
preset number
● Press ALBUM/PRESET +/- (or TITLE +/-
(í/ë) on the remote control) to select the
desired preset number.
3 Press PROG/CLOCK (or PROGRAM on
the remote control) again to store the radio
station.
➜ PROG disappears.
● Repeat steps 1–3 to store other radio stations.
To exit manual preset mode
● Press Ç.
Notes:
– If you attempt to store more than 40 preset
radio stations, "PROGRAM FULL" is displayed.
– During programming, if no key is pressed within
90 seconds, the system will exit the programme
mode automatically.
Tuning to preset radio stations
● Press ALBUM/PRESET +/- (or TITLE +/-
(í / ë) on the remote control) until the
desired preset station is displayed.
Radio Reception
Changing tuning grid
In some countries, the frequency step between
adjacent channels is 9 kHz (10 kHz in some
areas). The preset frequency step in the factory is
10 kHz.
1 Select tuner mode.
2 Press and hold 9 on the set for more than 2
seconds .
Note:
– All preset stations will be lost and need to be
reprogrammed.
FWM996_85_Eng 9/18/08, 16:1120